1. Remove lid and fill the metal insert(s) with the hot or strip wax of your choice. DO NOT put wax directly into the heating chamber, only in the removable inserts.
   NOTE 1: LYCON 800ml (27 fl.oz) strip wax jars are heat friendly and can be put directly in the heater without an insert.
2. Plug into power point and turn regulator dial clockwise to switch heater on.
3. To speed up hot wax heating, first turn the dial to 10 for at least 30 minutes, depending on how much wax is in the insert. When relatively melted, reduce heat and allow wax to cool to working temperature. For strip wax, heat on 10 until all wax is melted, then reduce heat slightly to maintain working temperature.
   NOTE 2: As all wax melting points vary, it is best to determine the optimal temperature setting for the wax you are using. For hot wax, the working temperature is around 4 – 6 on the dial. For strip wax, the working temperature is around 8 – 10 on the dial. The actual wax temperature is a few degrees lower, due to using an insert.
4. To increase temperature, move regulator dial clockwise.
5. To reduce temperature, move regulator dial anti-clockwise.
6. When wax is hot, always use the removable insert handle to lift the metal inserts out of the heater.

2 x 800g (28.2oz) capcity inserts

220 – 240 volts or 110 – 120 volts

Advanced heating technology

Moulded from durable heat resistant materials

Maximum temperature 105°C (221°F)

Fast heating

Easy to clean surfaces

Independant thermostat controls

Indicator lights

Protective clear lid

Removable insert handle included